![]() If the light is blinking, push the LOCK button to turn off the lock feature: Press and hold the LOCK button for 2 seconds, then the LED will glow solid indicating the lock feature has been deactivated. To deactivate this feature: Check for a blinking light on the multi-function door control panel. The door will, however, open and close by activating the push bar, key switch or keypad. With the LOCK button activated, the receiver logic board will NOT accept signals from the remote control. With this feature the indicator light behind the push bar will flash when the lock switch is turned ON and when you press the remote control the light bulb on the opener will flash two times. The Multi-Function Door Control Panel includes a LOCK button. There's a short in the door control, door control wire or receiver logic board.The remote control needs to be erased and reprogrammed.There are a few reasons for your remote control not to work: If all remotes are working intermittently, or stop working, there may be interference. The hand-held remote controls and wired door control operate independently, so it is not uncommon for one device to work while the other does not. Your garage door opener is equipped with an integrated receiver logic board that "listens" for your hand-held remote controls wirelessly, whereas your wall-mounted door control panel is hard-wired. A remote control uses batteries to send wireless signals, so a dead battery may cause it to fail even though the door control works.
0 Comments
Leave a Reply. |